VIEWING ON TV SCREEN
1Turn the TVon and set the input selector to
"VCR" whichever applicable Video input.
Refer to the TV instruction manual for how to
switch the TV input.
2 Turn the DVD video camera/recorder on.
The image that the DVD video camera/
recorder is seeing will appear on the TV
screen.
You can also monitor the image on the LCD
screen or viewfinder of the DVD video
camera/recorder.
3 Perform playback, recording or editing.
You can perform playback, editing or editing
on Disc Navigation while checking on TV
screen.
Note:
• Adjust the volume of sound on TV,
• The infrared remote control is useful when operating
the DVD video camera/recorder while viewing an
image on TV screen. However, if you use a Hitachi
VCR, the remote control may inadvertently operate
the VCR if it is near the DVD video camera/recorder,
To prevent this set the remote control code of the
VCR to a position other than "VCR2",
• Information during recording and playback will appear
on the TV screen: You can also switch off the display
during recording. Refer to "SETTING ON-SCREEN
DISPLAY OUTPUT ON OR OFF (OSD OUTPUT)" on
page 69,
• When copy-guarded disc is played back, no image will
appear on TV screen,
• If you use TV with wide mode (aspect ratio 16:9) and
set the TV to the wide mode, the entire Disc
Navigation display may not be displayed on the TV
screen. If this happens, release the wide mode setting
on TV (see the TV instruction manual for releasing the
wide mode),
113