Hitachi DZMV100A Camcorder User Manual


 
42
chapter 2_Setups
Cautions
During and after charging, the battery will be warm, but this does not indicate a fault.
If the POWER indicator on AC adapter/charger blinks, remove the battery once, and then reattach it. If
the POWER indicator still blinks, the battery may be faulty.
If the ambient temperature is a little too high or low, the CHG. indicator or CHG.80 indicator on AC
adapter/charger will blink at 6-second intervals. In this case, charging is possible, but it will take
longer than usual.
If the ambient temperature is too low or too high, the CHG. indicator or CHG.80 indicator on AC
adapter/charger will blink at one-second intervals, showing that charging will not be possible.
Attaching Battery to DVD Camcorder
Caution
Make sure that the battery is securely attached: Incomplete attachment could cause the battery to fall,
resulting in damage.
1. Pull out the viewfinder fully and raise it.
2. Align the top of battery with the top sur-
face of battery attachment platform of
DVD camcorder.
3. While fitting the battery onto the DVD
camcorder, slide it downward until a
click is heard.
Removing Battery
After using the DVD camcorder, remove the battery from it.
Cautions
For safety, be sure to turn the DVD camcorder off before attaching or removing the battery.
If the battery remains attached, minute level current will flow even if the DVD camcorder is off, and
the battery will discharge.
1
2 · 3