Hitachi DZMV100A Camcorder User Manual


 
53
Setting Date and Time
5. If the display is correct, press the Select
dial.
To correct the minutes, turn the Select dial to
change them and then press the Select dial.
Blinking will move to the AM/PM digit.
(The movement of blinking depends on the date
display format. Blinking will move from the digit
on the left end of the time in sequence.)
6. Perform the same procedure to correct
the AM/PM, month, day and year.
After setting the last digit, press the Select dial:
"OK?" will blink.
Tip:
If you make a mistake during the setting, turn the Select
dial to change to "SET" while "OK?" is blinking and then press the Select dial: You can start
over from the beginning.
7. Press the Select dial to again enter the date/time, and then press
the MENU button.
The menu screen will turn off.
To set the time to match the time signal
Set the minutes slightly ahead of the current minute, and make "OK?" blink. While
checking the time signal on TV or telephone, press the Select dial at the moment the
set time is reached.
Caution
You can change the display format of date and time: See “Changing Display Format of Date and Time”
on page 132.
Charging the built-in battery:
This DVD camcorder incorporates a battery to back up the date and time.
Connect the AC adapter/charger or charged battery to the DVD camcorder once
every two months, and leave the connection status for at least 24 hours with camcorder
power turned off: The built-in battery will be charged.