Filter
Top Products
. . . . . . . . . . . . . . . . . . . . . . . . . . . . .
7-46 Reference — Camera
7. Gently lift the camera back, and examine the imager in the light to
determine if it has been cleaned successfully.
8. If the imager is still dirty, repeat steps 2 through 7.
9. Place the camera back on a flat surface and breathe gently on the
imager to fog its surface.
10. Wipe repeatedly straight across the imager with a dry corner of the
cleaner pad.
11. Gently lift the camera back, and examine it in the light to determine if
it has been cleaned successfully.
12. If there is still lint on the imager, repeat steps 9 through 11.
Reassembling the Camera
1. Remove the ESD wrist strap from the edge of the plate on the camera
back and from your wrist.
2. Make sure the threaded end of the mounting screw is pushed into the
camera back.
Push