Filter
Top Products
. . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Reference — Kodak Driver Software 8-59
“Can not acquire image
‘imageid’
because
‘reason.’
”
This is a general purpose
message that occurs
when trying to acquire
images.
For example you might
see this message when a
calibration (CAL) file is
not found for the image.
Respond appropriately. For
example, if the calibration (CAL)
file is missing, you must obtain the
file (it was supplied by Kodak with
the camera used for the picture)
and place it in the folder with the
image file.
“Can not acquire this
contact sheet. The
Printable Area (Width and
Height) on the Acquire
Contact Sheet dialog box
is too small to hold even
one thumbnail of the
Thumbnail Size specified
on the dialog box.”
As indicated, the driver
can not acquire this
contact sheet because
the dimensions specified
for the contact sheet are
too small.
Either increase the Width and/or
Height as needed of the Printable
Area and/or reduce the Thumbnail
Size; then try again.
“Can not complete the
Copy To operation
because the disk is full.”
You are trying to save a
file that is larger than the
available space on the
selected disk.
Select another disk if available, or
delete files from this disk and try
again.
“Can not crop image
‘imageid’
because
‘reason.’
”
This is a general purpose
message that occurs
when trying to crop
images.
Respond appropriately as suggested
by the specified reason.
“Can not load camera
firmware because the file
‘filename’
can not be
found. Make sure the file
is at the same location as
the driver file (reinstall the
driver if necessary).”
A file, perhaps the
“.BIN” file, was not
found in the same folder
as the driver file.
Place a copy of the “.BIN” file in
the same folder as the driver file.
The BIN file is supplied by Kodak
on the diskette with the product.
Or reinstall the driver.
Message Possible Cause Suggested Solution