Filter
Top Products
. . . . . . . . . . . . . . . . . . . . . . . . . . . . .
4-24 Preparing the Camera and the Computer
1. Turn off the Macintosh PowerBook computer.
IMPORTANT: Later when you connect and disconnect the Macintosh
PowerBook computer and the camera on a regular basis, make sure the
computer is off.
2. Connect the AC battery charger/adapter to the camera as described
earlier in this chapter. Although this step is optional, we recommend it
whenever the camera is connected to a computer.
3. Attach the HDI-30-pin connector of your HDI-30-pin to 25-pin SCSI
cable to the HDI-30 port on the back of the Macintosh PowerBook.
Make sure the connector is well seated by pressing it into place firmly.
IMPORTANT: Do not use a terminator.
EOS•DCS Camera
SCSI Connector
BACK OF
POWERBOOK
COMPUTER
4. Attach the other end of your HDI-30-pin to 25-pin SCSI cable to the
SCSI connector on the back of the camera.
5. (Optional) Later, to disconnect the camera from the Macintosh com-
puter, shut down the computer and then power off the camera. Then
disconnect the SCSI cable from the camera and from the Macintosh
computer. Do not leave a SCSI cable with an empty connector/
terminator dangling from your Macintosh computer.
Continue at “Inserting and Removing a PCMCIA Card” later in this
chapter.