Filter
Top Products
. . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Reference — Kodak Driver Software 8-69
“The ‘Load Camera
Firmware’ command
failed. Refer to the
‘Messages’ section in the
User’s Manual.”
There may be one of a
variety of problems,
including loose or
incorrect cables,
improper SCSI
configuration, and so on.
Shut down the computer, turn off
the camera, and disconnect the
camera from the computer and the
AC battery charger/adapter. Check
all SCSI connections and cables.
Reconnect your equipment, restart,
and try again.
There is an unusual
condition with the driver
for Photoshop.
Choose the driver. If the problem
recurs, shut down your Macintosh
computer; restart the computer and
Photoshop, and try the driver
again.
If the condition persists, delete the
camera driver file from your
computer hard disk, and install the
driver again.
The “.BIN” file was not
found in the same folder
as the driver file.
Place a copy of the “.BIN” file in
the same folder as the driver file.
The BIN file is supplied by Kodak
on the diskette with the product.
“The number in the
‘Digits’ box is not large
enough to accommodate
the number in the
‘Starting From’ box.”
The value in the ‘Digits’
box is too small for the
value in the ‘Starting
From’ box.
Increase the value in the ‘Digits’
box or decrease the value in the
‘Starting From’ box so that the
value in the Digits box is large
enough to accommodate the
Starting From value.
“The PCMCIA card in the
camera is full. You can:
Enter Test Shot and
save images to a folder
using the Keep button.
Click Cancel, delete
images from the
PCMCIA card, then
choose Test Shot
again.”
You have tried to enter
Test Shot but the
PCMCIA card is full, so
additional images can
not be saved to it.
Since the PCMCIA card is full, you
can enter Test Shot and use the
Keep button to save images to an
archive folder.
Or you can, delete images from the
card, and then enter Test Shot. If
desired, new images can be saved
to the PCMCIA card which now
has room for the new images.
Message Possible Cause Suggested Solution