Filter
Top Products
. . . . . . . . . . . . . . . . . . . . . . . . . . . . .
4-20 Preparing the Camera and the Computer
7. Attach the supplied 25-pin terminator to the other end of the SCSI
cable and then to the camera.
25-pin Connector
SCSI Connector
EOS
•
DCS Camera
25-pin Terminator
8. (Optional) Later, to disconnect the camera from the computer, turn off
the computer and all external SCSI devices, and then power off the
camera. Then restore the SCSI cables and terminator to the state they
were in before the camera was connected. Do not leave a SCSI cable
with an empty connector dangling from a SCSI chain.
Continue at “Inserting and Removing a PCMCIA Card” later in this
chapter.
B. Follow these steps if the last connected
device is terminated internally.
1. Turn off the computer, and all connected SCSI devices.
IMPORTANT: Later when you connect and disconnect the computer and the
camera on a regular basis, make sure that all devices are off.