Filter
Top Products
36
Thumbnail display (continued)
Names and functions of thumbnail display screen parts (continued)
1 Display statuses
The types of information which are displayed on
the screen are displayed as follows.
ALL: All clips
SAME FORMAT: Clip whose format is the
same as the system format
SELECT: Clip selected by the STILL/
SET button
MARKER: Clip to which the shot mark
has been added
TEXT MEMO: Clip with text memo data
SLOT n: Clip on the P2 card in slot
“n”
PROPERTY: Detailed clip information
P2/REMAIN:
Media information
(remaining memory)
P2/USED:
Media information
(used memory)
META DATA: meta-data set on this unit
When you select SDI on the setting menu
“INPUT SELECT” and input a signal into SDI
input connector, input the same signal as the
one set on the setting menu “SYS FORMAT”. If
you input a signal with the different format, the
thumbnail display will be distorted also.
2 P2 card slot numbers and hard drive
statuses
1 2
P2 HDD
• P2 card
1 2
(Gray)
The numbers of the P2 card slots
where P2 cards have not been
inserted are displayed in gray.
1 2
*
(White)
The numbers of the P2 card slots
where P2 cards have been inserted
are displayed in white.
1 2
*
(Yellow)
The number of the P2 card slot,
which contains a P2 card with a clip
that has its cursor position recorded,
is displayed in yellow. When a single
clip has been recorded on a multiple
number of P2 cards, all the slot
numbers of the cards on which the
clip is recorded will be displayed in
yellow.
*
The frame is displayed in pink when the inserted
P2 card is in one of the following statuses:
RUN DOWN CARD (Page 84)
The maximum number of overwrites on the P2
card has been exceeded.
DIR ENTRY NG CARD (Page 83)
The directory structure on the P2 card is not
supported.
•
•
2
1
4
3
5
6
7
15
8 9
10 11 12 13 14