Filter
Top Products
- 12 -
Precautions for installation
Concerning the installation location of the camera
Ensure that the installation location is strong enough to bear
at least five times the total weight of the camera, lens, and
cables (approx. 55.1 lbs. [25 kg]).
When mounting to a pan-tilt head or to a mounting bracket
for installation, ensure that the location is strong enough to
accommodate its weight as well.
The camera cannot be installed or used in the following
locations.
Outdoor locations and locations where the camera may
be exposed to dripping, splashing or sprayed water
Locations such as swimming pools where chemicals are
used
Locations such as a kitchen where the high levels of
steam and oily vapors are present and locations with
flammable atmospheres or other unusual conditions
Locations where radioactive rays, X-rays or strong radio
waves or magnetic fields are generated
Locations where the temperature may be outside the
camera’s operating ambient temperature (14 °F to 113 °F
[–10 °C to 45 °C]) range
Locations near the air outlet of an air conditioner or near
a door where the camera will be exposed to incoming
outside air or other locations where the temperature is
subject to sudden change (since these locations may
cause the lens area to cloud over and/or condensation to
form)
Locations that are subject to significant vibration, such as
on top of a car
Locations with high levels of humidity or dust
When the camera is not going to be used, do not leave
it in place but be absolutely sure to remove it from its
mounting, and put it away.
Do not run the camera cable near the wiring of electric
lights.
This may result in noise interference.
Concerning electromagnetic interference
The camera’s images may become distorted or noise
interference may result if the camera is used near a
TV or radio transmission antenna or in strong electrical
or magnetic fields (such as one generated by motors,
transformers, etc.).
The connection and installation should be done by
qualified service personnel or system installers.
Refer any servicing to qualified service personnel.