Filter
Top Products
- 21 -
Example where the camera is mounted on a ceiling or wall
Mounting spacer
(supplied)
Mounting screw (M4)
Drop-prevention wire
(Ceiling)
Mounting screws
(Inch screws: 1/4-20UNC)
Camera mounting
bracket
Flat washers
Spring washers
Hitch the end of the wire
onto the anchor bolt by
tightening the nut or
screw or by using a hook.
Notes
When attaching one end of the drop-prevention wire to the
surface of a ceiling or wall, ensure that it is strong enough to bear
at least five times the total weight including the mounting bracket
or other part.
Tighten the mounting screws and mounting spacers using the
torque levels shown in the table to the right, and then check for
play and unsteadiness.
Screws/Spacer Clamping torque
Mounting screws (M4) 1.5N • m (15 kgf • cm)
Mounting screws (Inch screws) 2.0N • m (20 kgf • cm)
Mounting spacer 2.0N • m (20 kgf • cm)
Camera mounting
bracket
Mounting screws
(Inch screws: 1/4-20UNC)
(Wall)
Mounting screw (M4)
Mounting spacer
(supplied)
Drop-prevention wire
Flat washers
Spring washers
Hitch the end of the wire
onto the anchor bolt by
tightening the nut or
screw or by using a hook.
Mounting
The connection and installation should be done by qualified service personnel
or system installers. Refer any servicing to qualified service personnel.