Filter
Top Products
- 84 -
Component output setting
[Component: RGB, Y/Pb/Pr, Y/C]
This enables RGB, Y/Pb/Pr or Y/C to be selected as
the component signals which are to be output from the
I/F REMOTE connector.
Y/C cannot be selected when “1080i” or “720p” has been
selected as the “Video output format (Format)” setting.
If “1080i” or “720p” has been selected using the video
output format selection function while Y/C is selected, the
component output will be changed to Y/Pb/Pr.
(Refer to “Changing the component setting” on page 87.)
AWB/ABB operation status display ON/OFF
selection
[Status: Off, On]
(Factory setting: Off)
Using this item, the display of the operation status for
AWB (auto white balance adjustment) or ABB (auto black
balance adjustment) is set to ON or OFF.
When AWB or ABB is executed with this item set to “On”,
the following is displayed.
AWB ACTIVE: This is displayed while AWB is being
executed.
AWB OK: This is displayed for 3 seconds after
AWB was completed successfully.
AWB NG: This is displayed for 3 seconds after
AWB was not completed successfully.
(AWB executed while ATW, 3200K, or
5600K is selected)
OUT RANGE RB: This is displayed for 3 seconds after
AWB was not completed successfully.
(A color that could not be adjusted is
displayed with RB)
HIGH LIGHT NG: This is displayed for 3 seconds when
adjustment is not possible because
the light quantity is too high.
LOW LIGHT NG: This is displayed for 3 seconds when
adjustment is not possible because
the light quantity is too low.
ABB ACTIVE: This is displayed while ABB is being
executed.
ABB OK: This is displayed for 3 seconds after
ABB was completed successfully.
IRIS CONTROL NG:
This is displayed for 3 seconds when
the iris cannot be controlled by ABB.
OUT RANGE RGB:
This is displayed for 3 seconds after
ABB was not completed successfully.
(A color that could not be adjusted is
displayed with RGB)
Menu item setting/changing (User Mode)