Filter
Top Products
- 27 -
System configuration (Connections)
Connection of the Indoor Pan-tilt Head AW-PH360
Turn off the power of all the equipment before proceeding with the connections.
Connect the AC adapter (AW-PS300A) to the AW-PH360 indoor pan-tilt head.
Use 10BASE-T straight cables to connect the RP connectors on the pan-tilt heads with the CONTROL OUT TO PAN/TILT
HEAD (1 to 5) connectors on the AW-RP655 multi-function controller and AW-RP555 multi hybrid control panel.
The maximum extension distance is 3281 ft. (1000 m) when using UTP category 5 cables or their equivalent.
Connect the CONTROL OUT TO PAN/TILT HEAD terminals (P1 to P5) of the AW-RP400 and the RP terminal of the
AW-PH360 with a 10BASE-T straight cable when using the AW-RP400 pan/tilt control panel.
The maximum extension distance is 1640 ft. (500 m) when using UTP category 5 cables or their equivalent.
Use the camera cable provided with the pan-tilt head to connect the AW-PH360 to the unit.
Connect the iris control cable of the motorized zoom lens to the IRIS connector on the camera, and connect the zoom/focus
cable to the LENS I/F (1) connector on the pan-tilt head.
Set the Controller Selection switch SW1 located inside the AW-PH360 to the “Left Side (RP605)”.
Select “SDI supported” as the transmission signal selection setting.