Filter
Top Products
- 37 -
Connection of the Outdoor Pan-tilt Head AW-PH650 (continued)
When an SDI card (AW-HHD870) has been installed
Use a coaxial cable to connect the SDI OUT connector on the SDI card and the SDI IN connector on the AW-PH650 main
unit.
Use a coaxial cable to connect the coaxial connector (SDI OUT) on the AW-PH650 to the SDI input connector on the color
monitor.
When transmitting HD (1080i or 720p) analog component signals, set SW2 and SW3 on the COMP circuit board to the
HD position. The cable compensation circuit will not be activated even if SW1 is set to ON at this time so use this switch
at the OFF setting.
For the connections inside the housing and other details, refer to the operating instructions of the AW-PH650.
Notes
AW-IF400 Switch settings (when the AW-RP400 is used)
SW1 SW2
SET UP
1234
OFF ON OFF ON OFF OFF
System configuration (Connections)