Filter
Top Products
- 13 -
Concerning the mounting screws and drop-prevention
wire
Attach the drop-prevention wire as a way to prevent the
camera from dropping.
When the unit is to be mounted onto a Panasonic pan-tilt
head, use the mounting screws and drop-prevention wire
that are supplied with the pan-tilt head.
When the unit is to be mounted onto a surface other
than a pan-tilt head, provide your own drop-prevention
wire, mounting screws, washers, and camera mounting
bracket.
For details of the parts to be provided, refer to the next
page.
Before attaching the drop-prevention wire, fit the supplied
mounting spacer in the camera mounting screw hole.
The mounting spacer must be fitted securely using a
flathead screwdriver.
Note
Mounting screw (M4)
Drop-prevention wire
Mounting spacer (supplied)
Mounting screws
(Inch screws: 1/4-20UNC)
Pan-tilt head or
camera mounting bracket
Flat washers
Spring washers
Tightening the mounting screws and mounting
spacer
Tighten using the torque levels shown in the table below.
After tightening, check for play and unsteadiness.
Screws/Spacer Clamping torque
Mounting screws (M4) 1.5N • m (15 kgf • cm)
Mounting screws (Inch screws) 2.0N • m (20 kgf • cm)
Mounting spacer 2.0N • m (20 kgf • cm)
Precautions for installation
The connection and installation should be done by
qualified service personnel or system installers.
Refer any servicing to qualified service personnel.