Filter
Top Products
145
VQT2A80
Advanced (Playback)
Note
• The number of prints can be set from 0 to 999.
• With a printer supporting PictBridge, the date print settings of the printer may take precedence
so check if this is the case.
• It may not be possible to use the print settings with other equipment. In this case, cancel all the
settings, and reset the settings.
• If the file is not based on the DCF standard, the print setting cannot be set.
• [PRINT SET] cannot be set for motion pictures recorded in [AVCHD] and pictures that were
taken with the [QUALITY] set to [ ].
You can set protection for pictures you do not want to be deleted by mistake.
Select [PROTECT] on the [PLAYBACK] mode menu. (P29)
Press [‚] to return to the menu screen.
• Press [MENU/SET] to close the menu.
w Cancelling all the [PROTECT] settings
1 Select [CANCEL] on the screen shown in step 2 and then press [MENU/SET].
2 Press to select [YES] and then press [MENU/SET].
3 Press [MENU/SET] to close the menu.
• If you press [MENU/SET] while cancelling protection, the cancelling will stop halfway.
Note
• The protect setting may not be effective on other equipment.
• Even if you protect pictures on a card, they will be deleted if the card is formatted.
• Even if you do not protect pictures on an SD Memory Card or an SDHC Memory Card, they
cannot be deleted when the card’s Write-Protect switch is set to [LOCK].
P [PROTECT]
Press / to select [SINGLE] or [MULTI] and then
press [MENU/SET].
Select the picture, and then
press [MENU/SET].
When [MULTI] has been selected
• Repeat these steps for each picture.
• The settings are cancelled when
[MENU/SET] is pressed again.
[SINGLE] [MULTI]
Press / to select
the picture.
Press /// to
select the pictures.