Filter
Top Products
VQT2A80
86
Advanced (Recording pictures)
• When setting to [ ], ISO sensitivity will adjust automatically depending on brightness
within the maximum setting of [ISO800]. ([ISO400] when the flash is used)
• The maximum ISO sensitivity during motion picture recording is [ISO1600].
•
[ ] will operate as [AUTO] while recording a motion picture. Also, [ISO LIMIT SET] is fixed to [OFF].
w About [ ] (Intelligent ISO sensitivity control)
The camera automatically sets the optimum ISO sensitivity and shutter speed to suit the
movement of the subject and brightness of the scene to minimise the jitter of the subject.
• The shutter speed is not fixed when the shutter button is pressed halfway. It is continuously
changing to match the movement of the subject until the shutter button is pressed fully. Confirm
the actual shutter speed on the information display for the picture being played back.
Note
• The higher the value set for the ISO sensitivity, the more the jitter is reduced but the greater the
amount of picture noise.
• Refer to P66 for the flash range.
• Depending on the brightness and how fast the subject is moving, jitter may not be avoided even
if [ ] is selected.
• Movements may not be detected when a moving subject is small, when a moving subject is at
the edge of the screen or when a subject has moved at the very moment when the shutter
button was pressed fully.
• The setting is fixed to [ ] in the following cases.
– In [BABY1]/[BABY2] and [PET] in scene mode
– In [INDOOR PORTRAIT], [NORMAL SPORTS], [OUTDOOR SPORTS] and [INDOOR
SPORTS] in advanced scene mode
• Programme shift cannot be activated when the ISO sensitivity is set to [ ].
• You cannot select [ ] in shutter-priority AE mode and manual exposure mode. Also, you
cannot select [AUTO] in manual exposure mode.
• To avoid picture noise, we recommend reducing the ISO sensitivity, setting [NOISE RED.] in
[FILM MODE] towards [A] or setting the items except [NOISE RED.] towards [B] to take
pictures. (P87)
• If you want to set ISO sensitivity and record a motion picture, use the Creative motion picture
mode. (P108)
[REC] mode:
Change tone of the colour for the picture to be
taken (Film mode)
[You can only select [STANDARD] and [STANDARD] ( ) in [ ], [¿], [ ], [ ], [ ],
[ ] and [ ] mode.]
Every type of film for film cameras has its own colour tone and contrast characteristics. In
film mode, you can select the colour tone of the pictures from 9 types in the same way as
you would select different films for film cameras.
Select different settings in film mode to match the recording situation and your picture of
the recording.
Press [FILM MODE].
[FILM MODE] button