Filter
Top Products
149
Recording
∫ Displaying the MF Assist
•
It is displayed by rotating the focus ring or touching the screen. (In the Creative Control Mode
[Miniature Effect], MF Assistance cannot be displayed by touching the screen)
• It can also be displayed by pressing [ ] to display the setup screen for the enlarged area,
deciding the area to enlarge using the cursor button, and then pressing [MENU/SET].
• It will switch to the setting screen for the enlarged area by pressing the cursor button when the
[Direct Focus Area] in the [Custom] menu is set to [ON].
∫ Changing the display of the MF Assist
You can switch the magnification factor between approx. 4 times, 5 times and 10 times. In
the case of 4 times magnification, the central region is magnified. In the case of 5 and 10
times magnification, the whole screen is magnified.
•
To change the magnification, rotate the rear dial or touch [ ]/[ ].
∫ Moving the enlarged area
•
The enlarged area can be moved by dragging the screen (P15), or pressing the cursor button.
• The following will return the MF assistance to the original position.
– When the [Focus Mode] is set to other than [MF]
– Changing [Aspect Ratio] or [Picture Size]
– Turning the camera off
– Pressing [DISP.] when the setting screen for determining the area to be enlarged is displayed.
∫ Closing the MF Assist
•
It will close when the shutter button is pressed halfway.
• You can also close MF Assist by pressing [MENU/SET] or touching [Exit].
• When displayed by rotating the focus ring, it is closed approximately 10 seconds after the
operation is stopped.
• The MF Assist is disabled when using the Digital Zoom or recording motion pictures.
• MF Assist or MF guide may not display depending on the lens used, but you can display MF
Assist by direct operation of the camera, using the touch screen or a button.
MF ASSIST