Filter
Top Products
167
Recording
2 Press 3/4 to select [Start] and then press [MENU/SET].
3 Press the shutter button fully.
•
The recording starts automatically.
• During recording standby, the power will turn off automatically if no operation is performed
for a certain period. The Time Lapse Shot is continued even with the power turned off.
When the recording start time arrives, the power turns on automatically. To turn on the
power manually, press the shutter button halfway.
• When the [Fn1] is pressed while this unit is turned on, it will display selection screen for
pause or end. Operate in accordance with the screen. Also, when the [Fn1] is pressed
while paused, it will display selection screen for pause or end. You can also restart from a
pause by fully pressing the shutter button.
• This function is not for use in a security camera.
• If you leave the unit somewhere to perform [Time Lapse Shot], please be careful of theft.
• Recording for long periods in cold places such as ski resorts or places at high altitude,
or in warm, wet environments may cause a malfunction, so please be careful.
• Recording may be skipped when the recording time is longer than the recording interval, such
as long time exposure.
• We recommend to use a fully charged battery.
• [Time Lapse Shot] is paused in the following cases.
During [Time Lapse Shot], you can replace the battery and the card, and then restart by turning
on this unit. Turn off this unit when replacing the battery or the card.
– When the charge on the battery runs out
– When the number of recordable pictures drops to none
– Turning the camera off
• Do not connect the AV cable (optional), the HDMI mini cable (optional), or the USB connection
cable (supplied) during Time Lapse Shooting.
Applicable modes:
The electronic shutter can reduce the picture blur. Moreover, you can take pictures without
the shutter sound when the camera is used in a quiet location.
Settings: [ON]/[OFF]
•
Flash is fixed to [Œ] ([Forced Flash Off]).
• If a subject is moving or your hands are shaking, the subject may appear distorted on the
picture taken. Use of a tripod is recommended.
• Under the fluorescent lighting or LED lighting, etc., horizontal stripes may appear on the
recorded pictures.
• [Electronic Shutter] is disabled when [Burst Rate] is set to [SH].
• You can turn off the shutter sound at [E-Shutter Vol] in [Beep]. (P46)
• Be sure to pay special attention to the privacy, the likeness rights, etc. of the subject
when you use this function. Use at your own risk.
[Electronic Shutter]