Filter
Top Products
156
Recording
∫ Changing the settings for [Single/Burst Settings], [Step] and [Sequence] in Auto
Bracket
1 Select [Auto Bracket] in the [Rec] menu. (P37)
2 Press 3/4 to select [Single/Burst Settings], [Step] or [Sequence] and then
press 1.
3 Press 3/4 to select the setting and then press [MENU/SET].
•
You can take one picture at a time when set to [ ].
• You can continuously take pictures up to set numbers when set to [ ].
• Exit the menu after it is set.
• When taking pictures using Auto Bracket after setting the Exposure Compensation range, the
pictures taken are based on the selected Exposure Compensation range.
• The exposure may be compensated incorrectly, depending on the brightness of the subject.
• When taking pictures continuously using Auto Bracket with [i.Resolution] set to [EXTENDED], it
may take time to record all the set number of pictures.
• Auto Bracket is disabled in the following cases.
– [Glistening Water]/[Glittering Illuminations]/[Soft Image of a Flower] (Scene Guide Mode)
– [Miniature Effect]/[Soft Focus]/[Star Filter] (Creative Control Mode)
– When White Balance Bracket is set.
– When recording motion pictures
– When recording using the flash
– When [HDR] is set to [ON]
– [Multi Exp.]
– When using [Time Lapse Shot]
Item Settings
[Single/Burst Settings]
[ ] (single)
[ ] (burst)
[Step]
[3•1/3] (3 pictures)
[3•2/3] (3 pictures)
[3•1] (3 pictures)
[5•1/3] (5 pictures)
[5•2/3] (5 pictures)
[5•1] (5 pictures)
[7•1/3] (7 pictures)
[7•2/3] (7 pictures)
[7•1] (7 pictures)
[Sequence]
[0/`/_]
[`/0/_]