Filter
Top Products
313
14. Others
[Memory Card Error]/[Memory card parameter error]/[This memory card cannot be
used]
•
Use a card compatible with this unit. (P31)
[Insert SD card again]/[Try another card]
•
An error has occurred accessing the card.
Insert the card again.
• Insert a different card.
[Read Error/Write Error
Please check the card]
•
It has failed to read or write data.
Remove the card after turning this unit off. Insert the card again, turn this unit on, and try to
read or write the data again.
• The card may be broken.
• Insert a different card.
[Cannot record due to incompatible format(NTSC/PAL) data on this card.]
•
Perform formatting (P32) on this unit after saving necessary data on a PC, etc.
• Insert a different card.
[Motion recording was cancelled due to the limitation of the writing speed of the
card]
•
Use a card with SD Speed Class with “Class 4” or higher when recording motion pictures.
• In the event that it stops even after using a “Class 4” card or higher, the data writing speed has
deteriorated so it is recommended to make a backup and then format (P32).
Depending on the type of the card, motion picture recording may stop in the middle.
[A folder cannot be created]
•
A folder cannot be created because there are no remaining folder numbers that can be used.
Format the card on this unit after saving necessary data on a PC etc. (P32)
If you execute [No.Reset] in the [Setup] menu after formatting, the folder number is reset to
100. (P52)
[Recording stopped due to overheating. Please wait for the camera to cool down.]/
[The Wi-Fi connection will be terminated due to overheating. Please wait for the
camera to cool down.]/[Temporarily disabled. Please wait for the camera to cool
down.]
•
When a high ambient temperature, continuous recording in Burst Mode or of a motion picture,
continuous use of a Wi-Fi connection or other conditions are causing the camera to overheat,
[ ] flashes. If a message is displayed after [ ] flashes, the camera will turn off
automatically to protect itself. When this happens, some functions will be disabled until the
camera cools down.