Filter
Top Products
152
Error Messages
A message may appear while you are operating the DVD Video Camera. If a message appears, refer to
the following table and take appropriate corrective action.
Messages are arranged in alphabetical order.
Message Cause & Troubleshooting
Reference
page
(1) Data error in a part of
image file. Repair data
now?
(2) Found error in image
file. Repair data now?
(3) Data error in all
image file. Repair all
data now?
It is possible that the system cannot normally complete writing of file
when, for example, power is turned off for some reason during
recording or editing (deleting, dividing or combining scenes, or
creating play list). Selecting “YES” will automatically repair the
video file, but even if “NO” is selected, the same message will
appear when the DVD Video Camera is turned on next time. (Do not
remove the disc while the DVD Video Camera is recognizing it:
Ignoring this will deactivate the file repair function.)
Follow the instructions on screen, taking note of the following
cautions:
• Data may not be repaired, depending on the timing when power
was turned off.
• Data may not be repaired normally if data recorded on another
recorder is mixed in.
• The repaired data may be different from the original recorded
content because of partial deletion of defective portion.
• Since the date/time of repair is added to the repaired data (only
the corrected portion for partial repair), the original date/time
information will be lost.
• Since all movies, and then all stills, are repaired, the order of
recorded contents will be lost.
(In case of message (2) (3) only)
• See *1 on page 157.
(1) Error has occurred.
Please restart.
• Error has occurred. Try to restart the DVD Video Camera using
the following methods:
(1) Turn power off, remove the battery pack or AC adaptor and
reattach it, and then turn power on again.
(2) Turn power off, and reinsert the disc. Then turn power on again.
(3) See *3 on page 157.
(4) If you have another disc available, check to see if any problem
occurs with the disc. If another disc can be used normally, the
original disc may be defective: Contact the disc manufacturer.
If the above procedures cannot solve the problem, take note of
the error number, and contact your dealer.
Reference: “Error Code 2881” shows that the disc cannot be
recognized properly.
9, 42, 45, 46
(2) Error has occurred.
Please reinsert a disc.
(3) Error has occurred.
Error code No. xxxx.
Please read the manual.
(4) ERROR xxxx
(5) DISK xxxx
(1) This disc must be
formatted before it can
be used by this camera.
(2) Do not format this
disc if you want to record
from the PC connection
terminal.
(3) Format the disc now?
DVD-R disc that was not initialized for camera use was inserted.
47
Battery pack is almost
empty. Replace it.
Replace with a charged battery, or use AC adaptor to power the
DVD Video Camera.
42, 45
Cannot combine scene. Unless consecutive scenes are selected, they cannot be combined. 106