Filter
Top Products
74
Replacing Disc in Round DVD Holder
1 Open SIDE A of the Round DVD Holder, and replace
the disc in the holder with the SIDE A mark or label
surface facing up, taking care not to touch the disc
surface.
2 Close SIDE A of the Round DVD Holder, and push it
to lock the release levers at positions (3).
When the Hinge of Round DVD Holder Comes Off
1 Push the hinged portion of the holder piece marked
SIDE A with thumb and middle finger, and warp it in
the direction of arrows (4).
2 Fit the hinged portion of the other holder piece into
the warped hinge portion.
Note:
• Handle the disc carefully so that no scratches, dirt,
fingerprints or dust adheres to the recording/playback
surface.
• When not using the Round DVD Holder, store it in a case:
Do not leave a bare holder as is.
• Be careful of dropping or impact: If you drop the Round
DVD Holder, the disc may pop out.
• Do not subject the Round DVD Holder to force.
Disc Cleaning
Use a soft, dry cloth to lightly wipe off any dust, dirt, etc.
adhering to disc, as shown in the figure. Never use
solvent. Do not use thinner, water, anti-static spray, etc.
to clean disc.
3
3
SIDE A
mark
OPEN marks
SIDE A mark side or
Label surface
4
SIDE A mark side
Hinged portions
Approx. 90°
Use soft lint-free cloth to
clean from inner to outer
circumference in axial
direction, or use puffer to
blow dust off disc, like on
camera lens.