Filter
Top Products
12
2.2 Batteries for camera
Set the shutter release mode selector lever to “L” (to turn the power
off).
Use six “AA” alkaline.
NiCD batteries should only be used in the camerabody if CF07 is set
on rechargeable.
1. Lift the battery case lock lever, turn it counter clockwise and pull out
the battery holder.
2. Insert fresh batteries with the + and - ends as shown in the drawing.
3. Return the battery holder to its case and lock it by turning the lever
clockwise. Make sure it is rmly attached.
- Be sure the batteries are placed with proper polarity
Checking the Battery Power
Set the shutter release mode selector lever to “S” (to turn the power
on).
Check the battery condition in the lower right corner of the top LCD
display.
When replacing the batteries, be sure to use six new batteries of the
same type. Do not mix different types of batteries or old batteries with
new ones. NEVER throw out batteries.
C
S
L
M.UP
The batteries are sufficiently charged.
There is little power remaining. Have
new batteries on hand. Camera will still
operate.
There is very little power remaining.
Camera will not operate. Set the shutter
release mode selector lever to “L” (to
turn the power off) and replace the
batteries with new ones.
When the batteries are emptied for
power, “batt” flashes on the main
LCD and the viewfinder’s LCD when
the shutter release button is pressed.