Filter
Top Products
84
C-27 Flash sync. timing
When a moving subject has been shot using the ash, a ash of light
will appear ahead of the subject’s movement under the initial setting.
This function makes it possible to change this so that the ash of light
comes after the moving subject as illustrated.
0: No (front curtain synchronization: initial setting)
1: Yes (rear curtain synchronization)
C-28 Copy custom function
This function is used to group all the user symbol settings selected
(custom functions that have been set) together with the other user
symbols, and copy them.
0: No (initial setting)
1: Yes (copied to user A)
2: Yes (copied to user B)
3: Yes (copied to user C)
C-29 Custom function reset
This function is used to group all the user function settings selected
from C-01 to C-27 together, and initialize them (to the default
settings).
0: No (initial setting)
1: Yes
C-30 Shutter release without film
This function is used to set whether the shutter is to be tripped even
when the lm has not been loaded.
0: No (initial setting)
1: Yes
C-31 Auto film loading setting
This function is used to set whether to feed the lm (to the rst frame)
by halfpressing the shutter button or by closing the rear cover when
the lm has been loaded. The lm can be fed to the rst frame by
halfpressing the shutter button even when the rear cover close has
been established as the setting.
0: By half-pressing the shutter button (initial setting)
1: By closing the rear cover
When the camera is in sleep mode, the lm will not start moving even
when the rear cover is closed. Half-press the shutter button.
C-32 Multiple exposure mode
This function is used to select whether, during multiple exposure
shooting, the multiple exposures are to be taken by pressing the shutter
button until the multiple exposure button is pressed after the number
of multiple exposures has been set (initial setting). When the number of
multiple exposures is set, the lm is wound up by one frame after the
completion of the number of multiple exposures.
0: Until the multiple exposure button is pressed (initial setting)
1: Multiple exposure number is set
C-33 Digital back CF configuration
This function is used to select the user function (A, B or C) when an
MSCElisted digital pack has been loaded.
0: No (initial setting)
1: A
2: B
3: C
C-34 Clock/calendar setting
This function is used for setting the calendar and clock.
C-35 Index setting
This function is used for setting the index numbers. – ONLY relevant
when using lmback.
C-36 firmware version -
Press+/- to view rmware version: number on top of display is body
rmware. Number on bottom of display is rmware number for the
mounted lens.