Filter
Top Products
16
2.6 Attaching the back
The P+ back is fully integrated with the camera body and is a part of the
whole camera system.
When no cassette is attached to the Phase One 645AF camera house
the mirror is up and the shutter is open. This is the correct position
when no back is attached.
When attaching the P+ back to the camera body the shutter will close
and the mirror comes down. It is important to ensure that the bottom
part of the P+ back is pressed well into the locking mechanism on
the camera back before the upper locking mechanism is pressed
together.
Failure to do this can cause an error with the camera body. The error is
a state of continuously opening and closing the shutter. If this occurs,
remove the P+ back.
Please be aware that the shutter should be in the correct starting
position (shutter open), if this is not the case, attach and remove the
P+ back again to make sure that the camera body gets in the correct
starting position.