Filter
Top Products
13
2.3 Batteries for the back
When the system is unpacked the rst thing to do, is to give the batteries
a full charge.
In the Value Added Suitcase comes with two 7.2 volt Lithium-Ion batteries.
Only one battery is used in the P+ back at a time, but it is recommended
to charge both batteries fully before you start.
While charging the batteries, you can still use the camera back if you
connect it to the IEEE1394/FireWire port on your computer, by using
the 6pin FireWire.
The charger can adapt to voltages within a range of 110 to 250 volts.
It comes with an international set of source outlet adaptors (placed in
the suitcase utility compartment), please select one that ts your outlet,
and mount it by sliding it in from the top.
Connect the unit to the outlet and charge the batteries (approximately
2,5 to 3 hours).
NEVER throw out batteries, when a battery does not work, deliver the
battery for appropriate disposal.
Purchasing extra batteries
The Phase One P+ back comes with two 2500mAh batteries. If you
need to purchase extra batteries Phase One recommend Canon BP
915 2500 mAh.
Due to difference in the tolerances of some third party batteries, these
may not t into the digital back’s battery compartment. Do not try to
force a battery into the compartment. When pressing the battery release
button it should slide in without problems.
Warning!
•Only use the Charger to charge the specified batteries
•Do not allow charger to get wet or get exposed to moisture
•Keep the Charger out of reach of children
•Once charging is completed, unplug the transformer from power source
•Only use the original mains adaptor 12V DC or car lead
•Never apply excessive force when connecting or disconnecting a battery or contact
plate.
•Keep all contacts clean.
•Do not force down any of the contacts.
•Do not short-circuit the contacts.
•Never store the battery connected to the charger for an extensive period of time.
•Do not expose to excessive heat or naked flame.
•Do not dismantle or carry out any alteration to the product