Filter
Top Products
D:\Printer\DPPFP85.95 series\IM\3285420121DPPFP85.95IM_GB\3285420121\3285420121DPPFP8595IM_GB\050C03.fm
Master: Left
DPP-FP85/FP95 3-285-420-12 (1)
24
GB
When pressing AUTO TOUCH-UP cannot
reduce the red-eye phenomenon of a subject
shot by flash, you can adjust the image
manually.
Note
If you perform additional editing, such as enlarging,
reducing the image size, rotating or moving an image,
after the red-eye correction, the red-eye correction
may not take effect. Perform the red-eye correction
after these editorial operations.
1 From the Edit menu (page 18),
press g/G to select (Red-eye
Correction) and then press ENTER.
The adjustment frame appears on the
image, which indicates the range for red-
eye correction.
2 Adjust the position and size of the
adjustment frame.
Make the red-eye correction for the right
and left eyes separately.
x To move the adjustment frame
1Press g/G to select (Move) and
press ENTER.
2Move the frame with g/G/f/F.
The frame moves in the selected
direction.
3Press ENTER.
The frame is fixed in the current
position.
x To change the size of the
adjustment frame
Press g/G to select (Enlarge) or
(Reduce) and press ENTER.
Each time you press ENTER, the frame
becomes larger or smaller.
You can also enlarge or reduce the size by
pressing the (zoom in) or (zoom out)
buttons on the printer.
Tip
Make the size of the adjustment frame 2 to 7
times as large as the eye size.
3 Press g/G to select and press
ENTER.
The range of red-eye correction is
enlarged.
4 Press ENTER.
The adjustment takes effect.
The Red-eye correction menu is
displayed.
To make a red-eye correction for other
eyes, repeat steps 2 to 4.
5 Press g/G to select and press
ENTER.
The Edit menu is displayed again.
6 Press PRINT.
To reset the adjustment
Press CANCEL in step 5 instead of ENTER.
Correcting the red-eye
phenomenon
Adjustment frame