Filter
Top Products
CV503-8CH-19M
10
SVAT ELECTRONICS
now you can see
BASIC SETUP
CONNECTING ADDITIONAL DEVICES
CONNECTING A USB MOUSE
Connect the included USB mouse before powering on the
CV503-8CH. This will speed up the initializing process as
well as make the DVR easier to use.
1. Plug the USB connection on the mouse into the
top USB connection on the left side of the DVR marked
with a mouse icon.
Plug Mouse into USB port
CONNECTING A PTZ CAMERA
The CV503-8CH supports a 2 wire RS-485 connection for
a PTZ camera to be connected (PTZ camera not included).
Please see the PTZ camera manual for further instructions
on required PTZ settings.
To connect a two-wire PTZ camera:
1. With a small at head screwdriver, press down on the
plastic RS485 screw to open the port.
2. With the screw pushed down, insert the wire into the
wire port.
3. Release the screw to lock the wire in place. Pull lightly
on the wire to test for a secure connection.
4. For further instruction on connecting your PTZ camera,
please consult the PTZ camera’s instruction manual.
1.
2.
3.
CONNECTING A SPOT MONITOR
The CV503-8CH supports up to two spot monitors in addition
to your 19” LCD screen.
To Connect a Spot Monitor:
1. Connect a BNC-to-RCA connector to the video output
jack, labeled “VIDEO OUTPUT.” This is located on the left
side of the LCD-DVR.
2. Plug the included RCA cable into the BNC connector.
3. Attach the other end of the RCA cable to a yellow RCA
video input on your tv/monitor.
Plug RCA cable to Video Output