Filter
Top Products
LABEL LOADING
15
Each roll of labels or tape used in the VIPER LS6 is uniquely identified by the
mandrel holding the labels. This allows the operating system to automatically
set the printer for optimum usage of each label. Also, the operating system
keeps track of the remaining labels on each roll. Use steps 1-5 below to load
each label roll.
1. Ensure that the printer is turned OFF. If the printer is on, press the
and keys to turn the printer off. Insert the Label Roll into the socket
as shown above until it is firmly seated.
2. Ensure that the ribbon knob is in the locked position.
3. Insert the end of the label roll into the label guide path (see yellow
arrows). This requires positioning the label width guide to the proper
width. IF THE WIDTH GUIDE IS NOT LOCKED INTO A WIDTH
NOTCH, LABEL RECOGNITION FAILURE MAY OCCUR.
4. Labels should be inserted into the label path until resistance is met –
approximately ½”.
5. Turn the printer ON. Press the key to position the label for printing.
6. You are now ready to begin printing!
Label Roll
Socket
Label Roll
Width Guide
(Push Down to
Adjust)
Cutter Knob
(Pull Forward for
Cutting)
Label Door
Label Feed
Path
Mandrel