Filter
Top Products
SETTING UP THE VIPER™ LS6
45
Editing Label Mode
To edit the label mode, press to enter the setup menu and:
1. Use the up or down directional arrows to highlight Mode.
2. Use the right or left directional arrow keys to change the mode.
3. Press the key to select the desired mode. A check mark icon will
appear next to the selected mode.
4. Press the key to accept the changes and return to the home screen.
MODE DESCRIPTION APPLICATIONS
Component Vertically centers legend Electrical components
Wiremarker Repeats legend until label is filled Wire and cable marking
Terminal Places legends at terminal
locations
Terminal blocks
Tape Rotates legends 90° Safety/facility ID, pipe
marking
Strip Repeats legend until label is filled
and copies legend on two sides of
middle perforation
Wire and cable marking
Network Places legends at port locations Data communications
components
Using Printer Utilities
To use printer utilities, press to enter the setup menu and:
1. Use the up or down directional arrows to highlight Utilities.
2. Use the right or left directional arrow keys to change the utilities setting.
3. Press the key to select the desired utility. A new screen will appear
indicating either Battery, ViperLink, or Remote Printer.
The Battery utility is used to charge the battery. See section entitled
“BATTERY INFORMATION” on pages 9-11.
The ViperLink utility is used to interface with ViperLink™ software. See
sections entitled “INTERFACING WITH A COMPUTER” and
“VIPERLINK” on pages 49-52.