Filter
Top Products
CREATING LINES
34
The Line Tool
The line tool allows custom placement of vertical and horizontal lines on a
label. The line tool is especially useful for creating patch panel, faceplate, or
terminal block labels. There are seven unique line settings available: Center
Horizontal, Center Vertical, Top, Bottom, Left, Right, and @ Pages. Each
of these settings may be turned on or off independently.
NOTE: The top, bottom, left, and right sides of the label will rotate
with the legend when a label is rotated between 0 and 90
degrees.
1. The Center Horizontal setting places a line through the center of the
label in the horizontal direction.
2. The Center Vertical setting places a line through the center of the label
in the vertical direction.
3. The Top setting places a line at the top of the label.
4. The Bottom setting places a line at the bottom of the label.
5. The Left setting places a line at the far left side of the label.
A01
A02
A01 A02
A01
A01
A01