Filter
Top Products
34
6 Lightly press the shutter button
(pressing halfway) to focus.
Two beeps will sound when the camera has
finished focusing, and the AF frame appears
green.
z The AF frame will light yellow and the
beep will sound one time if the subject is
difficult to focus on.
z The shutter speed and aperture value are automatically determined and
show on the LCD monitor (or viewfinder). In addition, the camera will
automatically set the focus.
7 Press the shutter button all the
way.
You will hear the shutter sound when the
shot is complete.
Do not move the camera until you hear this
sound. The picture appears for two seconds.
See page 184 for settings that can be changed in this mode.
The field of view* of the LCD monitor and viewfinder is 100%.
* This is the percentage of the actual shooting field that can be viewed
in the LCD monitor (or viewfinder).
Images are first saved into the camera's internal memory before being
recorded onto the memory card, allowing the next images to be taken
immediately as long as sufficient space is available in the internal
memory.
The indicator blinks red while data is recorded onto the memory card.
The beep and shutter sound can be set to On/Off using the [Set up]
menu (p. 79).
Shots cannot be taken while the flash is charging (the white mark
blinks when pressing the shutter button halfway while the flash is
charging, and it stops blinking when shooting is enabled).
You can change the length of time images show on the LCD monitor
(or viewfinder) after shooting, or set it so they do not show at all
(p. 37).