Filter
Top Products
Paper is
curled.
If you are using paper with either any of the
corners or the whole printing surface curled, the
paper may become dirty, not feed properly, or
both. Use such paper after correcting paper curl
as follows.
(1) With the printing side (A) facing up, cover
the paper with a fresh sheet of plain paper to
avoid staining or scratching the surface.
(2) Roll up the paper in a direction opposite
to paper curl as seen below.
(3) Check to see that the paper curl is
corrected to within approximately 0.08 to 0.2
inches / 2 to 5 mm (B) in height.
We recommend printing curl-corrected paper one
sheet at a time.
Inappropriate
Paper
Thickness
Lever setting.
Adjust the position of the Paper Thickness Lever
according to the type of paper you are printing on.
See
Loading Printing Paper.
Depending on the printing content, the printing
surface may become scratched even for the types
of paper to set the lever to the left. In this case,
set the Paper Thickness Lever to the right.
* Reset the Paper Thickness Lever to the left
when you finish printing. If the lever is not set
back to the left, the inside of the printer is more
likely to get dirty due to the wider clearance
between the print head and the loaded paper. It
may also reduce print quality.
141