Filter
Top Products
edge of the stack.
When loading paper in the Front
Feeder, load the paper with the print
side facing DOWN. Align the right
edge of the paper stack against the
right edge of the Front Feeder and
slide the Paper Guide against the left
edge of the stack.
When loading paper in the Front
Feeder, make sure that the paper is
not set over the protrusion above the
Load Limit Mark on the Paper Guide.
For details on loading paper, see
Loading Paper.
Paper source
selection is
inappropriate.
You cannot load paper other than
A4, Letter, or B5-sized plain paper in
the Front Feeder. When using any
other type of paper, load it in the Auto
Sheet Feeder.
In the printer driver, select the
paper source where you loaded the
paper for Paper Source. For details,
see
Basic Printing.
Too much plain
paper loaded.
You can load approximately up to 150
sheets of 17 lb / 64 gsm plain paper in
the Auto Sheet Feeder (0.52 inches / 13
mm in stack height), and up to 110
sheets of 17 lb / 64 gsm plain paper in
the Front Feeder (0.39 inches / 10 mm
in stack height). However, proper
feeding of paper may not be possible at
this maximum capacity depending on
the type of paper or environmental
conditions (either very high or low
temperature and humidity).
In such cases, reduce the sheets of
paper you load at a time to around half
(around 0.2 inches / 5 mm in paper
stack height).
For details on loading paper, see
Loading Paper.
157