Filter
Top Products
1-3
Cisco Video Surveillance IP PTZ Dome Camera User Guide, Cisco 2900 Series IP Dome
OL-24281-01
Chapter 1 Installation
Mounting
Step 4 Pull the wiring into the back box through the conduit fitting.
Step 5 Connect all required wiring (see the “Wiring” section on page 1-4).
Step 6 Install the back box by compressing the spring clips and pushing the back box through the hole.
Step 7 Tighten the screws until you hear a clicking noise.
Pendant
Step 1 Install the mount for the pendant dome.
See the instructions supplied with the mount.
Note If the mount is outdoors, make sure it is properly sealed to keep moisture out.
Step 2 Open the hinged door to the back box by pushing the tab lock towards the wall of the unit and lifting the
door open.
Step 3 Pull the wiring into the back box.
Step 4 Connect all required wiring (see the “Wiring” section on page 1-4).
Step 5 Screw the back box onto the mount (see Figure 1-3).
If outdoors, apply thread compound (supplied) to the threads on the back box.
Note Thread compound must be applied. Not doing so may prevent the units from being separated in
the future.
Figure 1-3 Attaching the Pendant Back Box to the Mount