Filter
Top Products
E-2 FAQ Rev. D
Q 5. The Power LED is flashing slowly. What should I do?
A 5.1 Confirm the wireless setting of the TM-P60, AP, or PC.
Print out a status sheet for the TM-P60. Set the settings such as the network mode of AP or PC,
SSID, WEP, IP Address, and Channel to match the each other. See “Status sheet printing” (page
3-4) for how to print status sheet.
A 5.2 Confirm whether the TM-P60 is out of the wireless communication range.
There may be no access point or PC in the range where the communication is possible. When
there are obstructions between the AP or PC and the TM-P60, move the TM-P60 and confirm
that the LED does not flash.
When the AP is where there are obstructions or the AP is not on the same floor, move the AP or
the TM-P60 and confirm that communication is possible.
Q 6. The TM-P60 can’t connect to the Wireless LAN. What should I do?
The network mode for the TM-P60 is in the AdHoc mode as the initial setting. Print out a status
sheet and set the wireless LAN setting of the PC to match the TM-P60.
A 6.1 Confirm the wireless LAN setting of the TM-P60 and AP or host PC.
Confirm the wireless LAN setting of the AP (when you use infrastructure mode) or PC (when
you use Ad-Hoc mode) matches the TM-P60. The TM-P60’s wireless LAN setting can be
confirmed by self test. (See “Self test mode” (page 3-3))
(wireless LAN setting: SSID, IP address, subnet mask, WEP key, etc...)
A 6.2 Confirm that the IP address of the PC or AP isn’t the same as that of the TM-P60.
On host PC or AP, do not set the same IP address as that of the TM-P60.
A 6.3 There is interference with another network
When there is more than one wireless LAN network on the same floor and the same channel is
used, interference occurs. When the channels are close to each other, interference may occur. In
this case, one needs to be moved.
A 6.4 TM-P60 is near something that makes noise.
Communication may be difficult near a microwave or motor. Move the AP or TM-P60 and
confirm that communication is possible away from anything that makes noise.
A 6.5 Confirm TM-P60 is turned on.
Turn on the TM-P60.
A 6.6 Reset the TM-P60 to the default setting.
Reset the TM-P60 to the default setting (see “Resetting the printer” (page 3-6)). Then set up from
the first step (see “Installing your wireless LAN” (page 2-14).)