Filter
Top Products
3-4 Troubleshooting Rev. D
The printer is ready to receive data as soon as it completes the self test.
Note:
If you want to pause the self test manually, press the FEED button. Press the FEED button again to
continue the self test.
3.5.2 Status sheet printing
The status sheet describes the wireless LAN setting of printer. This sheet is useful to confirm the
current wireless LAN status.
A example of status sheet
To print a status sheet, follow the procedure below.
1. Make sure the printer is turned on. If it is off, turn it on.
1. Open the roll paper cover.
1. Press the FEED button until the printer beeps 1 time. (about 2 seconds).
1. Close the roll paper cover.
1. The printer prints the current LAN status (Status sheet), and then returns to the normal
mode.
Note:
After printing a status sheet, this printer doesn’t reset itself (keeps all setting values).
*** Dynamic Status Sheet ***
802.11b Interface
MAC Address :00-10-c6-24-62-cc
Hard Version :1.00
Soft Version :0.83
WLAN Pri F/W :4.4.1
WLAN STA F/W :8.42.1
Allowed Channel :07ffh
Wireless Status
SSID :EpsonNetIBSS
Network Mode :Ad-Hoc
Link Status :Connect 1
Channel :6
Transmission Rate :11Mbps
Access Point :00-0a-79-26-fd-04
Signal Level :-60dbm
Noise Level :-85dbm
TCP/IP Status
IP Address :192.168.198.168
Subnet mask 255.255.255.0
Default Gateway :0.0.0.0