Epson TM-P60 Photo Scanner User Manual


 
Rev. D Application Development Information 4-3
TM-P60 Technical Reference Guide
4.2.2.1 OPOS
In OPOS, the battery status can be confirmed by Direct I/O method
“PTR_DI_GET_BATTERY_STATUS.” This information is described in the manual “Application
Developement Guide POS printer (TM Series): (4.3 StatusUpdateEvent regarding Battery Status.)
This manual is installed with OPOS.
4.2.2.2 Advanced Printer Driver
The battery status can be confirmed by the Status API. The API is BiGetBatteryStatus.
Also, the battery status can be transmitted when the status changes. For this setting, use
BiSetBatteryStatusBackFunctionEx, BiSetBatteryStatusBackWndEx, BiCancelBatteryStatusBack.
See the “Status API user’s manual“ for details.
4.2.2.3 ESC/POS command
The beeper function can be operated by commands. See the “ESC/POS Application
Programming Guide“ for details.
4.2.3 Power Management function
The power management function is to save the battery. This function can be set from
TMNetWinconfig [“Power Management Setting” (page B-25)]. However, some Access points
don’t’t use this function with the TM-P60. See “Operation tested Access point products” (page 4-
2) for details.
4.3 Beeper function
This printer has a beeper function. The beeper beeps automatically when the following
conditions occur. The automatic beeping enabled/disabled is switched by a memory switch. See
“Memory Switches” (page 2-11) for details.
The remaining battery charge is low
The printer can’t find an Access point (wireless LAN).
Roll paper is out
Printer has an error
Also, the beeper can be beeped by a command from an application. The following sections
describe the method for each control method.
4.3.1 OPOS
On OPOS, the beeper function can be beeped by Direct I/O method “PTR_DI_RING_BUZZER.”
This information is described in the manual “Application Development Guide POS printer (TM
Series.)” This manual is installed with OPOS.