Filter
Top Products
2-4 Setup Rev. D
2.2 Setup Flow
You have to set up your printer to use it. And you can adjust some features by customizing
them. This section describes the setup.
The setup flow of preparing to use printer is below.
5. Complete setup
2. Adjust various settings (If you need to)
❏ Memory switches
❏ Paper width
(Adjust the spacer & Memory switches)
(See “2.5 Adjusting Various Settings” (page 2-10))
4. Driver setup
❏ OPOS
❏ APD
(See “2.7 Install a Printer Driver in the Host PC
/ POS Terminal,” page 2-25)
When you select
Direct control
method (ESC/
POS command,)
you don’t need
to install any
drivers.
1. Printer setup
❏ Install Roll Paper
❏ Install the battery pack or connect the printer to the
AC adapter
(See “2.4 Providing power to the printer” (page 2-8))
3. Install to your wireless LAN by either method.
❏ Using utility (TMNet WinConfig)
• with wireless LAN
• with serial connection (RS 232C
❏ Using browser
• with wireless LAN
(See “2.6 Installing your wireless LAN” (page 2-14))