Epson TM-P60 Photo Scanner User Manual


 
Rev. D Troubleshooting 3-5
TM-P60 Technical Reference Guide
3.6 Radio Field Intensity Check Mode
This mode prints the current radio field intensity on roll paper. This mode is useful to confirm
that the printer can communicate with an access point at the current location by radio.
1. Make sure the printer is turned off and the roll paper cover is closed properly.
1. Open the roll paper cover.
2. While holding down the FEED button, turn on the printer using the POWER button.
3. Press the FEED button 2 times.
4. Close the roll paper cover.
5. The printer prints the message “To start radio field intensity check, press FEED button.“
Then press the FEED button; the printer beeps to inform you that the printer has started the
radio field intensity check
6. When the check is completed, the printer prints the result on roll paper. When the printer
cannot complete the check within 4 seconds, the printer beeps with the following timing
until the check is completed.
Note:
Usually the printer completes this check within 2 or 3 seconds. When there are too many access
points, the printer requires more time to compete the checking.
This feature isn’t supported in Ad-Hoc mode. When executing this feature in Ad-Hoc mode, the
printer prints the following message.
7. Turn off the power.
100 ms ON
1900 ms OFF
Radio Field Intensity Check
To start radio field intensity check,
press FEED button.
This feature is not supported
in Ad-Hoc mode.
Radio Field Intensity Check
To start radio field intensity check,
press FEED button.
SSID: Planet
AP 1
MAC Address 00-a0-f8-a5-74-3f
Channel 11
WEP Enable
Signal Level -54dbm
Noise Level -96dbm
Radio Field Intensity Check
To start radio field intensity check,
press FEED button.
SSID:EpsonNetIBSS
No Access point found.
Print example when printer is
Ad-Hoc mode.
Print example when printer can’t
find any access point with the SSID
Print example the check
when the test is success.