Epson TM-P60 Photo Scanner User Manual


 
2-16 Setup Rev. D
Note:
The printed result (Status sheet) is necessary at the next step.
The printer may beep when turned on. It is caused by the host PC’s LAN setting not corresponding to the
printer’s setting. Ignore the beeping.
When you connect serial cable (RS-232C) at turning on printer, this mode is disable.
2.6.3 Adjusting the host PC to the printer’s LAN setting
When you set up the printer with serial interface, omit this section and read from “2.6.4
Connecting a serial interface cable” (page 2-16).
Adjust the LAN setting of the host PC corresponding to the status sheet. (It is printed at “2.6.2
Confirming the current LAN setting of the printer” (page 2-15).) The setting items are the
following.
Network mode (Ex: Ad-Hoc mode)
SSID (Ex: EPSONNetIBSS)
WEP (Ex: None) (This item isn’t printed on status sheet. This printer isn’t registered any
keys at shipped. When your printer isn’t registered any key, you have to set to “disabled”
this item.)
IP address (Ex: Auto, or 192.168.192.XXX)
(Don’t set the IP address of host PC the same as the printer’s setting.
Ex; when printer’s IP address is 192.168.192.168, set the host PC’s to 192.168.192.2.
Don’t set 192.168.192.168)
Subnet mask (Ex:0, 0, 0, 0)
Note:
For informatin about the PC setting method, see your PC’s manual or wireless LAN card’s manual.
The examples are for the default setting. You should use the settings printed on the status sheet.
After the setup, skip the “2.6.4 Connecting a serial interface cable” (page 2-16), and go to “2.6.5
Confirming the connection between the host PC and printer” (page 2-17).
2.6.4 Connecting a serial interface cable
When you don’t set up the printer with serial interface, omit this section and read from “2.6.5
Confirming the connection between the host PC and printer” (page 2-17).
Use the following procedure.
1. Turn off the printer.