Filter
Top Products
2-10 Setup Rev. D
2.5 Adjusting Various Settings
This printer is able to be adjusted for the items below:
❏ DIP switch (handshake of serial communication conditions)
❏ Memory switch (serial communication conditions, roll paper width,
print density, etc...)
❏ Roll paper width (58mm / 60mm)
Adjusting the spacer and memory switch
The current settings can be confirmed by a self test. (See “3.5.1 Self test mode” (page 3-3).)
Note:
When you adjust these items, we recommend you to confirm the new setting. You can confirm the settings
by running a self-test. See “3.5.1 Self test mode” (page 3-3) for detail.
2.5.1 How to Confirm Current Settings
You can use a self-test to confirm the current settings. See “3.5.1 Self test mode” (page 3-3).
2.5.2 DIP switch
This printer has DIP switches 1~4. These are located as shown in the figure below.
1. Make sure the printer is turned off.
2. To access the DIP switches, remove the DIP switch cover by hand (pull out the cover and
then pull it upward to release the projection.)
DIP switch cover
DIP switch
projection