Epson TM-P60 Photo Scanner User Manual


 
3-6 Troubleshooting Rev. D
3.6.1 Resetting the printer
Reset the printer’s LAN setting to be certain it is correct.
This mode is useful when you need to set the wireless LAN setting of a TM-P60 when the setting
cannot by changed by an Access point, serial cable, or TMNetWinconfig. In this case, reset the
printer to change the printer to Ad-Hoc mode for communication without any access point.
Note:
When you haven’t adjusted the printer’s wireless LAN setting, or you set up the printer with a serial
interface, you can omit the resetting. In this case, omit the resetting; then confirm the current setting.
The printer may beep when turned on. It is caused by the access point’s LAN setting not corresponding to
the printer’s setting. Ignore the beeping.
1. Open the roll paper cover.
2. Turn on the printer's power while pressing down the FEED button.
3. Press the FEED button 6 times.
4. Close the roll paper cover.
5. The printer prints the procedure for resetting. Follow the procedure. (Open the roll paper
cover, press the FEED button, close the roll paper cover.)
Then, the printer prints "Initialize" and cuts the paper, then starts resetting. Printer is rebooted
after the initialization.
Note:
This printer completes the initialization a few seconds after the paper is cut.
3.7 Hexadecimal Dump Mode
This feature allows experienced users to see exactly what data is coming to the printer. This can
be useful in finding software problems. When you turn on the hex dump function, the printer
prints all commands and other data in hexadecimal format, along with a guide section to help
you find specific commands.
To use the hex dump feature, follow these steps:
1. After you make sure the printer is off, open the roll paper cover.
2. While you hold down the FEED button, turn on the printer.
3. Close the cover.