Filter
Top Products
3-72 M3099GX/GH OEM Manual
Value
00000000b
01000000b
10000000b
11000000b
others
Description
Default: Simplified DTC (with IPC2)
Dynamic Threshold Circuit (with IPC2)
Simplified DTC (with IPC2)
Reserved
Reserved
Notes: 1. If simplified DTC is selected SDTC parameter will be
referenced.
2. If DTC is selected DTC mode will be referenced.
Paper Width X:
The paper width x field specifies paper width in 1/1200 inch
when paper size was specified as non standard paper.
Paper Length Y
This field specifies paper length in 1/1200 inch when Paper
Size was specified as Non Standard Paper.
Notes: 1. If the ADF is used and this parameter is not specified, the
paper is scanned as default paper size(A3 for M3099GX
or A4 for M3099GH).
2. This Paper Size is assuming the document which will be
fed through ADF. The window area specified in window
descriptor block (Upper Left X, Upper Left Y, Width,
Length) must be equal or less than specified paper size.
3. The Fujitsu Image Scanners calculate window origin from
ADF center, therefore, if Paper Size is not specified
window will be located in unexpected position.
DTC Selection: 00h, 40h(with IPC2), 80h(with IPC2)
The DTC selection field specifies which DTC is activated.
Table 3.53 DTC Selection
#03.pm5 98.2.22, 1:32 PM72