Filter
Top Products
M3099GX/GH OEM Manual B-5
SETUP MODE
C If you press the [Mode 1] at Screen 12, IPC-2
pre-set mode can be not used. Also the setting
is changed to “No” obligatory and stored to
EEPROM. If you press the [Mode 2] at
Screen 12, IPC-2 pre-set mode can be used
and the setting number is stored to
EEPROM.
When you close the setup mode, go to 9.
Panel/Host Set Ignore
No-Model Yes-Mode 2
Screen 11
Host Set Ignore
No-Model Yes-Mode 2
Screen 12
<Classification of user’s paper>
User’s paper are classified in line-art scanning as follows:
The horizontal axis shows the background density/color of paper.
The vertical axis shows the density of character/line.
1–5 are the pattern number set
in setup mode.
1: Normal background and
character.
2: Normal background and
light character.
3: Dark background and
normal-density character.
4: Light character on red paper.
5: Light character on green
paper.
<Notice>
(1) For patterns “1” to “5” when the power is turned on
Check that IPC-2 for front/back sides are installed during initialization.
If IPC-2 for either the front or back side is not installed, the scanner
regards as no setting obligatory and changes the memory of EEPROM.
(2) When IPC-2 pre-set is executed in setup mode
Check that IPC-2 for front/back sides are installed when the scanner
enters in IPC-2 pre-set.
If IPC-2 for either the front or back side is not installed, the scanner
does not enter in IPC-2 pre-set.
(3) When IPC-2 pre-set mode is executed
When IPC-2 pre-set mode is executed in online mode, the reading
parameter is valid or invalid (Host setting is invalid) as follows:
Background density Background color
Normal←→Dark Red
Green
Blue
Normal 13
Character
↑
density
↓
Light 245