Filter
Top Products
M3099GX/GH OEM Manual 3-117
INTERFACE
Endorser Control
The Endorser Control requires Endorser option. This endorser
function is assumed that a batch of documents are scanned and each
document is printed serial number. Therefore, ENDORSER
command just only specifies start and stop of endorsement and does
not interfere with scanning command sequence. Endorser Data is
sent to scanner a head of issuing ENDORSER command. The
endorser function is invoked by READ command internally.
Following shows simplex mode sequence. For Duplex mode, refer to
3.9.4.2.
ENDORSER(Start)
SET WINDOW(ID:00h)
SEND
SCAN(ID:00h)
OBJECT POSITION
(Load Object)
READ
OBJECT POSITION
(Unload Object)
ENDORSER(Stop)
SEND(Endorser Data)
Send "Endorser Data".
RESERVE UNIT
Reserve exclusive use of the scanner.
1
2
Specify document scanning parameter.
Send "Halftone Mask" and/or "Gamma Function" data, if
required.
Start endorser function by sending identifier with STOP
bit 0.
Feed document into ADF.
This command is omissible because SCAN or READ
command automatically feeds in a document.
Start scanning operation.
This command is omissible beacuse READ command
automatically starts scanning.
Transfer image data from scanner.
READ command would be issued one or more.
The details of READ command sequence is 4.9.5.
Feed out document from ADF.
This command is omissible because end of scanning
automatically feeds out document.
Stop endorser function by sending identifier with STOP
bit 1.
RELEASE UNIT
This loop is used to scan a batch of document.
This loop is used to scan a batch of identical format document at maximum speed.
1
2
Release exclusive use of the scanner.
#03.pm5 98.2.22, 1:34 PM117