Filter
Top Products
M3099GX/GH OEM Manual A-3
ENDORSER
EEPROM WRITE?
(Mode 2 Write)
Screen 5
5 To set the status in EEPROM, press [Mode 1]
until
*
blinks. Then press [Mode 2] to change the
LCD display into Screen 5. If you want to set,
press [Mode 2]. And the LCD displays Screen 6
about three seconds.
6 If you want to return to the ENDORSER
INITIAL screen (Screen 2), press [Mode 1] and
[Mode 2] at a time.
7 If you want to return to the initial status to read,
press [STOP].
A2.3 How to set the print number reset condition
You can choose whether to reset or not when HOPPER EMPTY is detected.
8 At Screen 1 press [Mode 1] nine times to go to the
ENDORSER RESET METHOD screen.
(Screen 7)
9 Press [Mode 2] to see Screen 8. If “ON” is
displayed, the print number will be reset when
HOPPER EMPTY is detected. If “OFF” is
displayed, it wouldn’t. The “ON” or “OFF”
status flips each time you press [Mode 1]. The
status will be set in EEPROM automatically.
10 If you want to return to Screen 7 , press [Mode
2].
If you want to close the job, go to 7 .
A2.4 How to reset the print number manually
You can reset the print number to the initial number by operator panel as
follows.
11 At Screen 1 press [Mode 1] ten times to go to
the ENDORSER RESET screen. (Screen 9)
EEPROM Writing!!
Screen 6
<< SETUP MODE >>
ENDORSER RESET METHOD
Screen 7
HOP-EMPTY RESET
ON
Screen 8
<< SETUP MODE >>
ENDORSER RESET
Screen 9