Filter
Top Products
5 - 9
2
6)
4) (g)
5) [F]
5) [F]
1
SW8062
Correct
Installing and inclined disc
cover could damage the switch
(SW8062) in side the disc cover.
Incorrect Incorrect
(i)
(h)
(a)
(k)
(a)
(m)
(n)
(i)
(j)
(f)
(h)
Disc
cover
[F] M1.6x2.5 (Black)
2)
(1)Unlock
(2)Pull
(1)
(1)
(2)
3)
1) (b)
(d)
(c)
(e)
(f)
(a)
(c)
(10) Disc Cover
1) Remove the space sheet (b) that covers the opening for operating lock arm.
2) Use a fine-tipped flat-bladed screwdriver to move the lock arm (d) in the direction of the arrow to
open the disc cover (a).
3) Disconnect the one flat cable.
4) Open the card slot cover (g).
5) Remove four screws [F].
6) Remove the disc cover in the direction of the arrow: Be careful not to damage the flat cable (h)
that extends from the disc cover.
Procedure and caution for reassembly
1) Reinstall the disc cover so that the hinge
1
of side case-R fits into portion
2
at the inside top of
disc cover, and that the cover is not inclined. Installing and inclined disc cover could damage the
switch (SW8062) inside the disc cover.
2) Pass the flat cable extending from the disc cover through the gap between the frame and side
case-R, and then connect it to the MAN-H/MAN circuit board (f).
(a) Disc cover
(b) Space sheet
(c) Opening for operating lock arm
(d) Lock arm
(e) AEL-H/AEL circuit board
(f) MAN-H/MAN circuit board
(g) Card slot cover
Fig. 5-3-12 Right Side
Fig. 5-3-11 Left Side
(h) Flat cable
(i) Hinge of side case-R
(j) Frame
(k) Side case-R
(m)Loader
(n) Disc drive unit
Disassembly and Reassembly > Disassembly