Filter
Top Products
-
Interchanging Finders
-
-___
--
--__-
-
l
Attaching Finders
*After removing a lens, be sure to
place caps on both the lens and cam-
era body
.
*Never touch the surface of the mirror.
*After removing a lens, it is recom-
mended to lock the shutter release but-
ton by setting the shutter release lock
ring (7) in order to avoid accidentally
releasing a cocked shutter when plac-
ing the camera bodv face down on a
table.
All finders are interchanged in the same
manner.
Prior to attaching the finder to the
camera, confirm that the white dot on
the finder release button is pointing
upward.
If the white dot on the button is aligned
with the white dot on the finder, by de-
pressing the button and removing your
finger from it, the white dot on the but-
ton will automatically point upward. In
this condition, the button cannot be de-
pressed; consequently, the finder
wiII
not be accidentally detached from the
camera.
Y
b-
Place the rear part of the finder on the
camera body while holding the front
part of the finder slightly upward. Slide
the rear part forward until it stops and
gently lower the front part of the finder
on to the camera body. It will then lock
into place.
18